|
October 5, 2005

Robertshaw Controls Company Announces Voluntary
Recall of TS-11 Thermal Safety Control Valve
Product : Thermal Safety
Control Valve: Robertshaw Controls Company, located in Carol Stream, Illinois,
is recalling about 123,544 TS-11 Thermal Safety Control Valves and about
37,350 magnet heads.
The voluntary recall applies to all TS-11 thermal
safety control valves produced between February 2003 and August 2004, along
with certain TS-11 components (magnet heads) produced between the same
dates, wherever sold, including outside the United States. These products can be identified
by date codes 0306 through and including 0432. These valves are used in commercial
cooking equipment, including ranges, griddles, fryers, and warming trays. The
date codes are on a white label affixed to the backside of the housing, below
the red button.
Hazard: If the pilot light in products that use
the valve goes out, the valves could stick in an open position, permitting
gas to continue to flow. This could result in a gas explosion and
fire, which could potentially result in severe personal injury and/or property
damage.
Incidents/Injuries: The firm
has received reports of approximately a dozen incidents with the TS-11
valve and as many as nine injuries.
What to do : Consumers should call Robertshaw's
toll free number at 1(800) 232-9389 or visit www.robertshaw.com to
determine if their product is involved in the recall and to obtain a free
replacement or repair.
Affected Manufacturers and Appliances/Products: A
list of manufacturers and models that contain recalled TS-11 valves is available
at www.robertshaw.com . This information
is also available via the hotline at 1(800) 232-9389.
Safety Precautions: As with any gas
appliance, if you smell gas near the appliance or in the building, immediately
leave the area and call your gas company or a certified gas technician
to investigate the cause. If you do not smell gas, check the pilot lights
on your gas appliances. If
any pilot lights are out, do not attempt to relight. Have
the appliance examined by the gas company or a qualified technician. If
the pilot is functioning normally (or if the gas supply to the appliance
is shut off), you will need to determine if your gas appliance has a valve
that is being recalled.
|